Sentence examples for limit width from inspiring English sources

The results show that an increase of skewness coefficient (α3) results in a slight decrease for sample size (n) while an increase of kurtosis coefficient (α4) leads to a wider control limit width.

We calculated precision based sample size estimates for a matched design under the following assumptions: vaccine coverage 50% and vaccine effectiveness 70%, with a confidence limit width of 30%.

Using a precision based approach, 17 we estimated that we needed a total of 170 case patients to compute a vaccine effectiveness of 60% with a confidence limit width of 30%, using a matched design with a control to case ratio of three to one and vaccine coverage of 50%.

In pin bearing, the limit width-to-diameter and edge distance-to-diameter ratios necessary to avoid unsafe failure modes were lower than those usually quoted for classical laminates.

The Table 1 contains the upper limit widths of the overdense plasma layer a and their appropriate dielectric layer d at which the transmission rate is over of 0.95%.

Design of control charts refers to the selection of parameters, including sample size, control-limit width, and sampling frequency.

The key fact behind this requirement is that the directional nodes have limited width of communication sectors, and thus, two nearby nodes must steer their communication sectors to each other for a successful communication [5 7].

The outcome was a decision to limit the width of the bat, a ruling that was signed off in the club minutes by Brett himself, along with the club captain, John Nyren, and their star batsman, John Small, who was also a bat maker: "In view of the performance of one White of Ryegate on September 23rd," it read, "that ffour [sic] and quarter inches shall be the breadth forthwith.

As for FmocKI4KCOOH, the steric hindrance effect can limit the width growth but the π − π stacking interactions can promote further association of the primary aggregate along the height direction to form nanofiber bundles.

However, the physical processes that limit the width of the mirrors depend on their relative locations to the receiver; the same applies to shading and blocking effects, that oblige to have a minimum shift between mirrors.

Cisternal shapes and possibly budding vesicles could be seen, but the size of these structures is close to the resolution limit (the width of a cisterna corresponds to 2 4 pixels), preventing the segmentation and 3D reconstruction of Golgi stacks.