Sentence examples for limit the torque from inspiring English sources

When the lift-drag ratio and the tip-speed ratio is approaching infinity, power coefficient of the ideal wind turbine is close to the Betz limit; The torque limit is 0.401 when the tip-speed ratio equals about 0.635; The Lift limit is 0.578 when the tip-speed ratio equals about 0.714; The thrust coefficient is 8/9, which is unrelated with tip-speed ratio.

Carefully increase collective and be sure not to exceed the yellow limit of the torque gauge.

The speed of the brushless motor is limited by the torque the motor can generate and the torque is inversely proportional to the rotary speed of the motor.

The scanning speed is also limited because the torque cable can vibrate when operated at rotary speeds higher than a few thousand revolutions per minute (rpm).

Flat and V belts slip when overloaded, and in some applications this condition may be more desirable than a rigid drive because it limits the transmitted torque and may prevent breakage of parts.

Since the maximum speed of the MotPS motor is about 50 Hz even in the presence of 200 mM NaCl, either Na+ transit through the channel of the MotPS stator, Na+ release from the channel to the cytoplasm or both may limit the rate of torque generation cycle of the MotPS motor.

The rates of force development and relaxation can limit the production of torque and power during fast cyclical movements [ 41– 41].

For implementation of this specific control law on a real-life aircraft, emergency situations must be considered in which the pilot needs to exceed the torque limit of the aircraft intentionally to ensure safety.

During acceleration in first gear the diesel engine powers the DMU without traction support from the storage because the engine torque already exceeds the torque limit of the hydrodynamic torque converter.

Of these 30 patients, 6 (1 woman and 5 men) were excluded from the analyses because they did not perform the knee extension measurements according to the standardized procedures and because they exceeded the torque limit of 218 Nm.

All of the peripheral non-locked screws were then implanted within the torque limits observed, ensuring that each screw placed provided similar fixation.