A measured light power of ~2mW is exposed on the sample, which is within the American National Standards Institute safety limit [ 32].
Once the heathens reach the food bin area, use the lighting power on them again.
As soon as they start moving towards it, use the lighting power on the heathens to scare them off.
It is worth noting that a wide field illumination technique, such as structured light approach, allows one to increase the light power impinging on the phantom while preserving a low power density; e.g. by assuming a light source of 100 mW the power density over 64×64 mm is about 2 mW cm-2.
Transmitted and reflected light power dependence on the grating period, wavelength, and polarization was systematically measured and compared with the designed dependence.
Herein, we report on the effect of altering mAb-IR700 and light power and dose on effectiveness of PIT.
The light source for measurement of PDT effect was a white light (a 200 W Xenon lamp that passes through a 400 700 nm mirror module) finally, the light power was 100 mW/cm−2 on the sample surface.
The onset time constant was dependent on the light power density, but 4 9 ms in this case.
In a ChR2V-expressing RGC placed under whole-cell voltage clamp at −60 mV (Fig. 3A), a blue light-emitting diode (LED) light pulse evoked an inward current whose amplitude was dependent on the light power density (Fig. 3B).
