Sentence examples for lifetime samples from inspiring English sources

For a more detailed investigation of the interaction of mc-Si and AlOx passivation during degradation,a photoluminescence-based"effective defect imaging has been performed on AlOx-passivated mc-Si lifetime samples.

Investigations on lifetime samples showed a 2.5-fold increase in effective lifetime and an efficiency gain of 0.7 % absolute (max. efficiency 18.6 %) for surfaces passivated by an Al2O3/SiN x stack compared with fully metallized Al-BSF rear sides.

Using 223 ASD and 285 healthy controls (HC) from the autism brain imaging data exchange (ABIDE) lifetime sample [ 2, 22], we examined both group differences and diagnosis-age interactions in local functional homogeneity measured by 2dReHo, as well as behavioral correlations in ASD.

The ZrO2 Ni/Al gradient coatings on the surface of steels prolonged the lifetime of samples and changed the corrosion behaviour of the samples in molten zinc.

Fig. 4 The effective minority carrier lifetime of samples etched by solutions A and B with different post-etch treatments, using polished wafer as a reference.

At the same time, the corrosion test showed that lifetime of samples with MoB CoCr coatings in molten zinc appeared to be longer than that of WC coating.

Time resolved photoluminescence measurements show no decrease in Shockley Read–Hall carrier lifetime for samples with rougher interfaces and a rise and then decrease in lifetimes with increasing growth rate.

Samples were etched by solution B and without any post-etch treatment after Ag+ removal Fig. 10 The effective minority carrier lifetime of samples etched for 5 min and 10 min, respectively, under the conditions of indoor lighting illumination and bulb illumination.

In order to verify the plasmonic resonances of Au NPs on QDs films, fluorescence lifetimes of samples were measured using a 375 nm excitation source at room temperature.

Figure 9 and Table 3 show that under the same reaction conditions, the lifetime of sample S-1 was about 80 min with 81% selectivity to ethylene and propylene, whereas the lifetime of S-3 sample with the thinner layers and the largest surface area could reach 180 min with 87% selectivity to ethylene and propylene.

Changes in spectra and lifetimes in samples are ascribed to the accumulation of α,β unsaturated aldehydes and α,β diketones and the loss of volatile organic components (including acetophenone).