Sentence examples for levels of velocity from inspiring English sources

In the real-world traffic environment, there are many vehicles driving with various levels of velocity in many streets.

Based on the results of optimisation it was observed that the lower to intermediate levels of rotational speed and intermediate to higher levels of velocity ratio produced good coating quality.

High KT values indicate high levels of velocity transfer through a linkage system, with a low KT signifying greater force transmission.

Table  1 gives the different combinations of movement amplitudes, movement durations, and average velocities presented to the three groups in the experiment.> Eight levels of velocity ratio were factorially combined with three levels of movement amplitude, movement duration, or average velocity (depending on the specific conditions in each group), resulting in 24 different stimuli per group.

Figure  4A presents the average percentages of acceleration judgments of the constant-amplitude group for each of the three levels of paired movement duration and average velocity, as a function of the eight levels of velocity ratio (negative velocity ratios indicate deceleration and positive velocity ratios indicate acceleration).

The effects of two levels of velocities (0.4 and 2.2 m/s) and four levels of voltages (0, 20, 25, and 30 kV) on drying kinetics, drying rate, final moisture content, and specific energy consumption of EHD system (SECEHD), convective system (SECtunnel), and combined convective-EHD system (SECtotal) were studied.

RPE is a reliable method in monitoring and regulating exercise intensity, with high correlation to oxygen uptake (r ≥ 0.83) [ 42] and high internal consistency at different levels of velocities and heart rates (α > 0.90) [ 43].

As a result, inflow turbulence satisfied the prescribed spatial correlation and power spectral density and the level of velocity divergence was sufficiently reduced.

The level of velocity fluctuations in the solid phase was higher than that of the gas phase at the bend entrance and this possibly pointed to an early formation of particle rope.

Comparisons show that the OEM has a better performance in reproducing the correct level of velocity and temperature fields around the body as well as in other locations of the room while the SST SAS model fails to predict these quantities accurately, especially around the occupant's body.

Stirred tank (STR) flows at low and moderate Reynolds numbers show poor mixing behavior due to formation of segregated zones inside which both magnitude and fluctuation level of velocity components show lower values compared to the active fluid regime (i.e., impeller jet stream, circulation loops).