Sentence examples for levels of tensile from inspiring English sources

This research studies the effect of two different levels of tensile Hoop stresses on the failure life and formation of WECs in the rings.

Earthquake damage was simulated by inducing two levels of tensile strains in the rebars corresponding to the desired levels of pre-damage.

The stress states considered are essentially simple shear, with various levels of tensile stresses or compressive stresses superposed, i.e. low positive stress triaxiality or even negative stress triaxiality.

A basic study has been made on the effect of varying levels of tensile overloads on the crack growth rate in aluminium alloy that are being used extensively in fighter jet aircraft.

Finally, industrially produced PLA-PMMA-Biostrong composition showed high levels of tensile strength, rigidity and ductility for a wide range of strain-rate and is, therefore, suitable for use in highly-loaded technical parts.

The most important factors responsible for the high levels of tensile strength and ductility and fatigue life were a refined grain size, a fine distribution of particles, a low level of porosity and a reduction in the level of bifilm formation.

Several techniques may be used to reduce the high level of tensile stresses in the top layer of the weld near the welding toe.

Within the tension zone of a cracked reinforced concrete beam, the intact concrete between adjacent cracks is able to sustain certain level of tensile stresses and contribute to the flexural stiffness of the beam.

We show that the applied torques and angles of twist at the buckling and failure stages strongly depend on the level of tensile loading and on the twist direction.

Indeed, by using the cryogenic cooling, a reduction of more than 40% of the surface roughness could be realized, a higher level of work hardening occurred, a lower level of tensile residual stress was measured and better resistances to stress corrosion cracking and pitting corrosion were noticed.

The failure mechanism of the joints could be controlled by the level of tensile stress of reinforcing steel bars.