Sentence examples for levels of solids from inspiring English sources

However, treatment is complicated because of the high levels of solids and fats and lack of knowledge of degradation mechanisms.

Ceramic colloidal processing methods require stable, well-dispersed suspensions with extremely high levels of solids loading to achieve optimal casting condition and green body properties and also to minimize drying induced shrinkage [9 11].

For the suspension of high levels of solids the D="T/2 hollow blade turbines, at a clearance of T/4, are found to be amongst the most efficient agitators especially under gassed conditions, where almost no effect of gassing on the just suspension speeds were noted.

This reflected the glucose yield for the entire experiment, and controlled for varying levels of solids recycle and glucose removal during the recycles.

The comparison for predicted and actual solids remaining is presented in Figure 10, this showing good correlation but with some offset at the very low levels of solids remaining achieved using flocculation.

At low centrifuge throughputs there are slightly higher levels of solids carry over for the thawed as compared with the fresh cell broth, this probably reflecting the differences in size distributions at the fine end with the former containing peaks in the submicron range (compare Figs. 1 and 2).

An analytical evaluation was developed to assess damage states and performance levels of solid reinforced concrete bridge columns (Kim et al. 2007).

Three levels of screw speed (1, 3 and 5 rpm), two levels of solid flow rate (12and 24 kg/h) and three levels of liquid flow rate (15, 25 and 35 lph) were selected.

Taken together, these results show that AC-20 and AC-30 age differently based on their respective SARA fractions content: AC-30 displays higher levels of strain than AC-20 because of its increased levels of solid fractions.

This external efficiency is superior to those of previous photochemical, photosynthetic, or photoelectrochemical systems and approaches the levels of solid state photovoltaic devices which are more complex to fabricate.

So, the energy positions of MLs on the spectra connect with electron interatomic transitions between the energy levels of solid and adsorbed atoms and with initial intense increasing and next relaxation of local charges in surface layers and under-surface dielectric substrate.