Sentence examples for level of scattering from inspiring English sources

Many studies reported that the threshold of PGA causing nonlinear site response is >100 cm/s2 (e.g., Régnier et al. 2016; Dhakal, et al. 2017); (2) to ensure a relatively low level of scattering of the HVSR results, each station should provide at least three records that match criterion (1).

Thus, it is not necessary to use the typical statistical calibration curve, which assumes an average level of scattering and an averaged concentration over individual subjects.

Therefore, in conventional spectroscopy, the statistical calibration curve is assumed to be for an average level of scattering, and the average concentration is prepared by making measurements on many subjects.

With numerical simulations we have shown that an increase in energy affects not only the level of scattering wing, but also both the shape and the absolute level of the PSF core.

We evaluated the level of scattering blood induced by using the safety ICs under a simulated condition to clarify the measures for prevention of blood-borne infections to HCWs.

As both hot and cold samples show about the same level of scatter about the LOE.

The results show the significance of the load sequence at the level of scatter and non-exceedance probability of resistances.

However, test data from small specimens tend to have a high level of scatter as these materials contain several centimetres of chopped carbon fibre strands.

This method can take into account the level of scatter that exists in the material characterisation test data and in long term component oxide and crack damage measurements.

In this paper, we have quantified the relative contribution and the importance of each source of uncertainty and shown the level of scatter in results that a well informed CFD user may obtain in a typical design activity.

In the literature, enormous level of scatter on permeability plots of ambient and in situ measurements has been reported (e.g., Byrnes 1997; Byrnes et al. 2009) with the average difference in situ permeability, being on average reported is 20 times less than that measured at low stresses.