Sentence examples for length sections from inspiring English sources

The structure consisted of two, 15 m length sections of Type-III turbidity curtain with a skirt depth of 4.57 m, but adjustable with furling lines.

Figure 9c, d: As assigned liquid rate is increased from 200 to 300 m3/day, cumulative oil production increases for all horizontal length sections examined.

Segmentation methods, based on local and global thresholding, were investigated and evaluated by a quantitative comparison of the architectural parameters they yielded, such as the fibre orientation and segment length (sections between joints) distributions and the number of inter-fibre crossings.

Pre D-day appendices of the Sauromatum and Arum inflorescences were cut transversely into equal length sections and immediately placed either in inducer solutions with different final concentration or in a control solution (without the inducer) in a 96-well plate in an environmental chamber (SANYO) under constant light and temperature.

The dendritic spine density of CA1 pyramidal neurons was quantified along 30 μm length sections of primary and secondary dendrites, at 50 μm from the cell soma and, expressed as number of spines per 10 μm (n = 5 10 cells/animal; 4 5 animals/group from ≥ 3 experiments).

Since there was no difference among the images of different root length sections [see Supporting Information —Fig. S1 ], for a comparative root anatomical analysis of WT and ewst1, 10 µm root sections were obtained using Ultra-microtome (Leica EM UC7) at 1 cm from the root tip in three replicates.

The "Local rainfall as a function of coastline length" section describes the general feature of tropical rainfall concentration near coastlines.

The effects of various parameters such as bond length, section types, tensile modulus of CFRP, adhesive layer thickness and adhesive types have been studied.

The effects of gauge length, section area, volume and thickness of the specimens on the measured tensile response of the UHPFRC were experimentally discovered.

Bar-slip formulation in the configuration of the bilinear steel material is used for zero length section elements to consider bar slip in joint interfaces.

The strain capacity, energy absorption capacity and the number of multiple micro cracks within unit length obviously decreased as the gauge length, section area and volume of UHPFRC specimens increased.