TiB showed three different morphologies: fine needles (200 nm diameter, 15 μm length); plates (thickness 1 μm, short length 3 μm and long length 15 μm); and coarse needles (diameter 3 μm and length of 50 μm).
Phase separation, emulsion-solvent diffusion, and porogen leaching were used to create poly(l)lactide (PLA) scaffolds containing both computationally designed global pores (500, 600, or 800 μm wide channels) and solvent fashioned local pores (50 100 μm wide voids or 5 10 μm length plates).
Numerical results also show that the transmission coefficient will be always small if the dimensionless plate length (plate length versus incident wavelength) exceeds a certain moderate value.
Racers routinely ignored the regulations but now every Olympic competitor is tested near the finish line for ski length, plate and boot height and sometimes for the width of their ski's center.
The optimal values of air flow rate, tribo-charger length, plate voltage and plate angle were found to be 7 LPM, 240 cm, −6.5 kV and 20°, respectively.
The influences of various aspect ratios including gradient index, crack length, plate thickness, cutout size, and boundary conditions on the CBTR are investigated.
Number of screws, cortices and empty screw holes proximal and distal to the fracture, plate-span ratio (plate length divided by overall fracture length), plate-screw density (number of inserted screws divided by number of plate holes), fixation failures, delayed or nonunion, malalignment and leg length discrepancy were documented.
After reaching 50,000 cycles, the mean stiffness of the long working length plate group decreased while the mean stiffness of the short working length plate group continued to increase, although the difference was not significant between stabilization techniques.
There was a trend for the stiffness to increase during cycling in both the short and long working length plate groups until 50,000 cycles.
The implant has an adjustable, fenestrated core and adjustable-length plates which allow for expansion and compression.
Several important geometric parameters, such as the beam width column width ratio, beam thickness column thickness ratio, plate length, and plate thickness are considered to understand their effect on the connection moment capacity and sources of inelastic rotation.
