Step twisting of stepper parts with simultaneous axial loads extend the deformed region to the whole length of the sample.
The Dirac-like temperature function is measured by two thermometers located in the gage length of the sample.
Thickness of the agarose layer and length of the sample DNA were important factors affecting hybridization efficiency of immobilized probe to PCR product.
In the case of continuous loading non-linear ultrasonic (NLU) measurements were conducted after fracture at different locations along the gage length of the sample.
(TiO2)x(HfO2 1 − x films with a monotonously varying coefficient "x" over the length of the sample (combinatorial library) were prepared using the physicochemical features of atomic layer deposition (ALD) method.
From this analysis, a W-band (94 GHz) cylindrical cavity is designed where modulation slots are optimized to present a uniform 100 kHz field modulation over the length of the sample.
The joint sample includes two full-scale joints, one in the hairpin configuration at the bottom of the sample and one as an overlap joint at mid length of the sample.
With the equipment it was possible to obtain TMF cycles with cycle times of 120 s with less than 10 °C temperature variation over the measurement length of the sample, cycling between 200 °C and 550 °C.
In the case of PB films having an average spherulite diameter of about 20 μm, the macroscopic deformation was homogeneous over the whole gauge length of the sample, up to rupture.
One-dimensional radial profiles showing the diffusion of water into the depots were produced at points along the length of the sample and, for some short immersion times, axial profiles were obtained for the cylinder ends.
The simulations were repeatedly conducted to test the effects of the average asperity height, the standard deviation of the asperity heights, the length of the sample, and the material constants.
