Sentence examples for length of the clusters from inspiring English sources

The length of the clusters is typically in the 20 to 25 bases range.

The density of repetitive sequences (calculated by dividing the total length of repetitive sequences by the length of the clusters analyzed) in the caecilian Hox clusters was 3.3 %, among the lowest densities of all the species studied (Fig.  2).

And "density of repetitive sequences", which was calculated as the ratio of the total length of repetitive sequences to the length of the clusters in each species, was used.

Although the average length of the clusters was the same, the balanced PTR combiner produced more singleton clusters (namely, 12 out of 25, as compared to 5 out of 25 for the unbalanced) and a few very large clusters.

With the increase of reaction time, the orientation adhesion degree increases; and thus, the length of the cluster increases.

The length of the cluster is selected on the basis of the correlation between the columns of the sensing matrix Ψ.

Optimization is only necessary for ambiguous clusters C ( t - δ : t ), ν, therefore N = ν specifies the number of flies in this cluster and T = δ + 1 specifies the length of the cluster.

The length of the cluster is measured as the number of genes in this cluster.

3' UTR clusters were selected that extended beyond the annotated 3' UTR by more than 30%% of the length of the cluster.

For CNE density, we averaged the total length of CNEs present in the whole cluster over the non-repetitive noncoding sequence length of the cluster.

We identified 939 3' UTR clusters that extended beyond the annotated transcript by more than 30%% of the length of the cluster.