These plates with a length of overlap improve ductility and their connection zone with half-ring plates is placed in an elastic zone.
This order mismatch effect can be minimized by increasing the length of overlap between the adjacent segments.
Differently from the previous specimen types, in γ specimen the length of overlap between the plates is 30 mm (Table 1).
Other practical issues, which also exist in the STFT, including the effects of window width and the length of overlap between adjacent signal segments will be discussed.
Important factors that affect resolutions of signal representation, such as the window width, the length of overlap between signal segments, order mismatch and estimation errors of polynomial coefficients, are discussed.
Also in this case the length of overlap between the plates has been set at 20 mm and the maximum loads applied to the specimens are 700 N for t1 thickness and 900 N for t2 thickness.
where N is the length of the input signal, q is the length of the window (or signal segment), and l, 0 ≤ l ≤ q - 1, is the length of overlap between signal segments.
Then we will discuss the effects, in terms of the resolution in the time-frequency domain and the minimization of the required computational complexity, of window width, order mismatch, i.e., using the second order LPFT to process higher-order PPS, and the length of overlap between signal segments.
It was shown in [28] that when the second order LPFT is used to process the chirp signals, the length of overlap between the adjacent signal segments can be significantly reduced without obviously degrading the signal resolution in the time-frequency domain, which allows us to further minimize the required computational complexity.
For such assembly to be reliable, the length of overlap between any two reads must be sufficient to identify their common origin [22].
Though this program has the option of calculating the optimum length of overlap given a target uniform Tm, no such parameters were defined for either construct.
