Sentence examples for length of blast from inspiring English sources

Table 1 Data on drilling patterns of three blocks Row Parameter Value Standard deviation 1 Blast holes diameter (mm) 76 – 2 Average stemming length of blast holes (m) 2.25 0.2 3 Bench height (m) 8 0.5 4 Specific drilling (m/ton) 0.06 – 5 Sub-drilling (m) 1 0.7.

Mean(Length%) is the mean of the length of all blast results for the orthologs of the cluster, where length is defined as the minimum of length of (blast hit/ length of query sequence) and (length of blast hit/length of subject sequence).

The average length of BLAST hits from clones with PBHs was significantly greater than the length for hits from clones with a single successfully BLASTed end sequence (Supplementary Table S4 in Additional File 1).

As expected, the number of reciprocal 'best hits' varied depending upon the E value threshold, although increasing the E threshold by several orders of magnitude had a disproportionately small effect on the overall total length of BLAST alignments.

The 'with BLAST' group (average length = 1,124 bp) had larger TAC sizes than the 'without BLAST' (average length = 405 bp), and same to the ORF sizes (mean length of 'with BLAST' and 'without BLAST' groups were 730 bp and 209 bp, respectively).

As contigs created from the different assemblers differed in their read length, number of BLAST hits and position along a transcript, we additionally investigated whether a meta-assembly, thus the combined assembly of all four contig sets might increase contig information.

Following JIN et al [52], our blast search results were selected using the following two criteria: (i) that the e-value of the blast hits be lower than e−10; and (ii) that the length of the blast hits be longer than 200bp and the sequence identity be higher than 85%.

The blast results were evaluated by two criteria: (i) that the e-value of the blast hits must be lower than e−10; and (ii) that the length of the blast hits must be longer than 30% of the query length.

The stable taphole length decreases the wearing of thehearth lining and increases the whole campaign length of the blast furnace.

In addition, the relative length of the BLAST hit (i.e. coverage, or length of the hit divided by the length of the query sequence) had to be at least 80%.

We executed clasp using the sum-of-pair cost model with, (only punish for distance differences with half of the match score) fragment scores according to the length of the BLAST hit, and a minimal required chain score of 30.