The phrase "length limit is" is correct and usable in written English.
You can use it when discussing restrictions or specifications regarding the maximum length of something, such as text, documents, or physical objects.
Example: "The length limit is set to 500 words for this essay."
Alternatives: "maximum length is" or "length restriction is".
In the capture below, the "Feed" tab provides the intended, "old normal" reading experience, one abstract after the other: Now, if you select the "Readable" tab, the feed length limit is gone, you get the full article, regardless of its size, within the G-Reader.
In the latter case, it is convenient to define the hyperpolarizability per unit cell, β/N or γ/N, which, in the infinite chain length limit, is equivalent to the nonlinear susceptibility.
Second, and just as important, the needs of the reader must be considered: On the whole, shorter papers tend to be read by more people, and if the goal is to reach an interdisciplinary audience, a tight length limit is always desirable.
Model estimates showed that increased minimum length limits were much more effective than stock enhancement for increasing SPR and angler catches in exploited populations, but length limits resulted in reduced harvest.
I have had the good fortune (or ill luck, depending how you look at it) to work for two journals where the length limits are particularly tight: Reviews in TREE are supposed to be 2500 words, with 35 references; Reports in Science are also 2500 words--but that includes references and legends, too.
In the optimization, the lower limit D of maximum directivity is set as the nominal directivity (D = 43.353 3), the cable tension constraints are same as the first step, and the tie cable length limits are set as l (i) − 2mm and l (i) + 2 mm, respectively.
Actual values of maximum daily instantaneous mortalities and length limits were determined to mimic our experimental 75% per-generation harvest rate.
Finally, small-selected fish did not perform well when random harvesting (with respect to body size) or dome-shaped size-selective harvesting (representing large-selection with a harvest slot-length limit) was operating (Table 5, Supporting Information S7; Fig. S3).
When the calculation is done using 4.5 nm, the predicted length lower limit is lowered by 25%, which encompasses all of the data points except for the two at the highest salt concentrations.
The deflection for each member is constrained to l/360 of the member's length and this upper limit is used for all three cases.
* mean lengths were calculated as 10^ average(log10( inter-CDS lengths))); ** location of lower limit is defined by 2% quantile of the inter-CDS length distribution in each category.
