In order to achieve different TiO2 nanobranch length, the deposition was conducted at 6, 12, 18, and 24 h respectively.
SEM was used to measure the channel length after deposition (60 100 μm range), the value of which was used to model of the electrical data.
ISD-VGS curves for TFTs with different channel lengths and deposition time of (a) 5 min; (b) 15 min; (c) 30 min, and (d) 90 min.
Capacitance-voltage characteristics for devices with different channel lengths and deposition time of (a) 5 min, (b) 15 min, (c) 30 min, and (d) 90 min, measured at a frequency of 100 kHz.
Finally, the rate of addition of Zn atoms is found to control the tapering where the tapering limited to the nanowire base gives way to a continuous taper along the nanowire length at higher deposition rates.
The effects of tube length, liquid volume, deposition time, the profile of the Ba2+ concentration in the outlet and the pressure drop in the tubing were evaluated using a graphite furnace atomic absorption spectrometer (GFAAS) and pressure transducer methods.
The ratio of the longitudinal length scale of deposition predicted by the macroscopic model to that given by the microscopic analysis is 0.85 for α = 0, decreasing monotonically to zero as α increases toward 1.
We produced copper nanowires of 3 nm in diameter and up to 150 nm in length by electroless deposition within the 4 nm wide channel of tobacco mosaic virus (TMV) particles.
Fiber length modulates fiber deposition in, and clearance from, the respiratory airways, and consequently fiber retention.
Here, MoS2 nanopetal stacks bearing partial negative charge were decorated with positively charged gold nanoparticles (with mercaptoalkylammonium functionalities of two different lengths) via droplet deposition of individual components on indium tin oxide.
