This was compared to the measured room/lamb leg temperature.
Prior to sonications, the temperature recorded from baseline PRFS measurements (n = 138) in lamb leg sample number 1 was 22.5 ± 0.5 °C (mean ± SD) compared to the measured room/lamb leg temperature on that day (21.5 °C).
However, it was recently found that the temperature of upper region of APR-1400 reactor might be little lower than or similar to hot leg temperature through the review of detailed design data.
No additional cooling was observed in this phase except on windier days, when leg temperature and respiration rate reductions tended to be more marked (slope estimates: −0.06 and −3.6, respectively).
The research has been carried out to analyze the hot and cold leg temperatures, Steam Generator (SG) pressure, SG Narrow Range (NR) level, SG water-level-percentage (PCT), Pressurizer pressure, Fuel Temperature, and containment pressure.
Simulation results suggest that failure in closing PORV has negligible impact on hot and cold leg temperatures, results in an overall less pressure in SGs, but higher pressure in the pressurizer.
The regenerator can operate with a maximum hot leg inlet temperature of 900 °C and transfer 180 kW to the cold leg using 100 g/s helium at 4 MPa.
A correlation was proposed to estimate leg centre temperature from shoulder temperature.
Their relatively long legs mean temperatures at the height of their bodies are 6-7 degrees cooler than on the ground.
Only spraying cows for ≥3 min reduced leg surface temperature during spray duration (range of reduction: −0.1 to −0.6 ± 0.0°C).
