Row 15: k2cr, k4bk, k4bk, pult (leave 4 sts unworked on left needle).
(The working yarn will be attached to the left needle).
The tip of the thread was grasped with the left needle holder, and the thread was pulled through the pad, leaving a 2-cm tail on the opposite side.
Now you will have two stitches on your left needle.
Hold your needles so that the left needle has the knitting on it, the needle points are facing away from you, and the yarn is leaving the needle to the right, on the bottom side of the needle.
(If you are a right handed knitter, you will slip the stitches off the right needle and onto the left needle).
bbl inc [bobble increase] k1 (do not drop stitch from left needle), yo, k1, yo, k1 all into same stitch (there will be 5 loops on the needle within the one stitch).
Row 7: K7bk, k4cr, k4bk, pult (pick up loop below next st on left needle by inserting tip of right needle from back through loop – this stops a hole forming when turning work – then turn, leaving rem 3 sts on left needle unworked).
The positively charged (red) clip was connected to the right needle and the negatively charged (black) clip was connected to the left needle.
The positively charged (red pole) clip was connected to the right needle and the negatively charged (black pole) clip was connected to the left needle.
Pull the loop off the left needle.
