Sentence examples for leakage p from inspiring English sources

NSE levels were positively correlated with AI as a marker for BBB leakage (P < 0.0001).

In contrast to their non-diabetic counterparts, diabetic WT mice showed significantly greater areas of focal leakage (p < 0.01) (Fig.  3 a, b).

AG extract at doses of 25, 50 and 100 mg/kg significantly reduced BBB leakage (P < 0.001, respectively) compared with that of the vehicle group.

It is worth noting that none of the 20 patients with a temporary diverting stoma in comparison with two of the remaining 9 patients (17.6%) without a diverting stoma experienced anastomotic leakage (P = 0.085).

The curves for the relative fluorescence light intensity were comparable before, during, and after discontinuation of bosentan, although after 8 weeks, when comparing the area under the curve, a trend towards increased NaF leakage (p = 0.051) was observed (Table  3).

There was a significant association between the severity of leakage on the RSS and the resolution time of the radiological leakage (p = 0.010), the day of resumption of oral intake (p = 0.000) and the hospital stay (p = 0.015) (Table 2).

In a univariate analysis, factors significantly associated with referral to a specialist were: 'anal discharge' and 'uncontrolled anal leakage' symptoms (P = 0.01 and P = 0.01, respectively); and a rectal examination (P = 0.05) (Table 3).

Open image in new window Fig. 2 Impact of site of placement of OSTEOSET®-T placement and the presence of a post-operative wound leak (p = 1.0, Fisher's exact test) Open image in new window Fig. 3 Impact of wound leakage on healing (p = 0.06, Fisher's exact test).

Compared to the MSP algorithm, the AHT algorithm iterates rapidly to a point with low leakage interference P I. Actually the main consuming time of AHT algorithm is used to reduce P I from less than 1 towards 0.01, and the convergence rate becomes much slower when P I is smaller.

The only difference between the LIM problem and (8) is the objective function, as LIM minimizes the total leakage interference P I subject to (8b).

And the y-axis represents the total leakage interference P I. Figure4 implies that to achieve the interference of 0.5 from the initial point, the AHT algorithm requires 7.5% of its total iterations while MSP requires 45%.