Sentence examples for layers of fe from inspiring English sources

Above 3.77 atomic layers of Fe the domains are probably perturbated by the tip and therefore cannot be imaged.

We further fabricated tubes with thicker layers of Fe (120, 150, and 200 nm), but those micromotors did not provide significant faster or further degradation of organic pollutants.

These effects are expected to be slightly different in goethite, where the H nuclei occupy positions inside the 2 × 1 tunnels, than in lepidocrocite, where the H are sited between H-bonded layers of Fe octahedra whose spacing has been shown to be more sensitive to the details of the calculations.

Space weathering is attributed to the solar wind, which triggers the formation of Fe nanoparticles in amorphous surface layers of Fe-bearing silicates.

After surface modification, it was covered with a layer of Fe ions.

A thin layer of Fe (~2 nm) supported with Al2O3 (~10 nm) was used as the catalysts.

By applying secondary etching of 0.5 nm, the majority of resputtered material and the top layer of Fe catalyst film were removed.

We believe that the addition of Fe layer plays a crucial role in alignment of CNTs due to the formation of uniform layer of Fe catalyst nano particles on the surface of the substrate [14].

In order to improve the oxidation resistance in air and mechanical properties of Fe foam prepared by electrodeposition on polyurethane foam, a surface aluminizing layer of Fe foam was obtained by a convenient pack cementation method.

The micromagnetic simulations were carried out using the LLG Micromagnetics Simulator software [17] on a single triple-layer dot, which is composed of a hard FM layer of Co with thickness of 3 nm and a soft FM layer of Fe with thickness of 21 nm separated by vacuum representing an insulating barrier of thickness 3 nm.

It was found that the intrinsic rate of reduction in H2 is substantially faster than with CO, whereas the resistances to diffusion of H2 and CO through the product layer of Fe are comparable; these factors account for differences in the overall rates observed with these gases.