Sentence examples for layers of cable from inspiring English sources
Numerical analysis shows that the main reason for such deformation is pressure from layers of cable, while other reasons – a "rolling spot" of stress near the rope-barrel contact point, barrel bending and torsion – play a small role.
Dense layers of cables suggest to him a "data center mille-feuille".
Different complexities of tensegrity structures are constructed by different layers of cable-strut net [18].
It was based on the familiar principle of the bicycle wheel; its roof had a diameter of 100 metres (330 feet), with a steel tension ring at the perimeter from which two layers of radial cables were tightly stretched to a small tension ring in the middle the double layer of cables gave the roof stability against vertical movement.
The Oakland Alameda County Coliseum (1967), by Skidmore, Owings & Merrill, extended this system to 126 metres (420 feet) in diameter, but only a single layer of cables, stiffened by encasing ribs of concrete, connects the inner and outer rings.
Semiconductive polymer shielding layers of power cable require stable volume resistivity to protect the insulation layer from stress enhancements when carbon black (CB /polymer composite undergoes thermal cycles.
The two layers of tie cables are connected by some cables.
The bicycle-wheel roof involves two layers of tension cables radiating from an inner tension ring and an outer compression ring, which in turn is supported by columns.
Three situations are considered: (i) XLPE-covered cables with brand new insulation; (ii) XLPE-covered cables with punctured insulation; (iii) bare cables, aiming at assessing the critical case in which the insulating layer of the cable is completely deteriorated.
Adding a layer of tie cables reduces the impact of frame vibrations on the membrane, but the cable mass and risk of deployment failure caused by cable windings will increase.
Another funicular form is the bicycle-wheel roof, where two layers of radiating tension cables separated by small compression struts connect a small inner tension ring to the outer compression ring, which is in turn supported by columns.
