Sentence examples for layer slightly from inspiring English sources

Five tons of soil would fill a small dump truck; spread over an acre it would make a layer slightly less than the thickness of a dime, Mr. Cruse said.

The thickness of SiO2 layer slightly increased after annealing.

This layer slightly increases the corrosion resistance and the fatigue strength limit of the titanium alloy, and essentially increases its frictional wear resistance.

After binding of Rose Bengal (RB) guest molecules to dendrimers, an assay using the Klotz plot showed that the hydrophobic amino acid layer slightly affected the guest site number, but significantly increased intrinsic binding of the dendrimers to guest molecules.

In the in vivo study using BMP-2 gene, DLp-Ap layer slightly increased BMP-2 protein concentration than D-Ap layer, thereby enhancing their osteogenic differentiation than D-Ap layer.

The introduction of a low-index layer slightly increases the mode volume to λ3/1000 or 0.040 (λ/n 3, where n is the refractive index of the high-index slab.

The R sei values, as a measure of the hindrance for lithium-ion conduction through the SEI layers, slightly decreased in the initial 50 cycles but then rapidly increased in the following cycles.

The gate effect on the modulation of Donnan potential, ionic conductance, and ion selectivity in the biomimetic soft nanochannel is remarkable when the background salt concentration is low, pH is close to the isoelectric point of PE brush layers (slightly acidic), and the grafting density of PE brushes on the channel wall is small.

While the architecture of star-shaped PCL Langmuir layers slightly influences their degradability compared to OCL films, significantly retarded degradations are observed for P OCL-U) films containing urethane junction units derived from 2, 2 (4), 4-trimethyl hexamethylene diisocyanate (TMDI), hexamethylene diisocyanate (HDI) or lysine ethyl ester diisocyanate (LDI).

The other 2 authors with LANL panel face size 10, the largest size, achieved fit factors of 13 and 17 by making the prototype mask inner layers slightly larger (22 cm).

The cup is best if the layers slightly overlap, to create less opportunity for leakage.