Sentence examples for launching speed from inspiring English sources
Open image in new window Fig. 15 Simulated test runs (different launching speed and motion sense) with emergency braking Open image in new window Fig. 16 Experimental speed profiles measured on ten braking test runs (different launching speed and motion sense) with emergency braking.
The sensitivity of error on braking distance to the correct evaluation of the launching speed, as shown in (3), produces about 2 3%% additional uncertainty on estimated braking distance.
This phenomenon causes a variability of about 1 2 km/h on the measured speed with respect to the mean value (about 1 %–1.5 % with respect to the launching speed).
For the selection of the best system alternative, a trade study for the first stage engine type and launching speeds is performed using a sequential optimization technique, confirming the feasibility of the baseline air-launching rocket.
The injector has a maximum launch speed of 450 m/s.
A simple launch speed calibration technique, methods of eliminating the electromagnetic signal effect and erasing magnetism in bars are also described.
gravity versus launch speedThe launch speed required for a spacecraft to escape Earth's gravitational pull differs depending on its trajectory.
Lincecum goes five-eleven and an official hundred and seventy pounds (you hear one-sixty-three), while Koufax, a lean six feet two and two hundred and ten pounds, didn't need any gearing or spiralling to attain launch speed.
As with any product launch, speed is of the essence, and Davidson credits the Accelerated Buying Experience with helping the team go to market faster.
Thus, the validity of these inferred estimates of launch speed is limited by the assumptions of the drag modeling.
Glass Treatment: The surface of the glass substrates was cleaned by rinsing in a 1 300 diluted HF water solution for 10 min. Jumping Dynamics Estimation: Assuming 50% of the elastic energy turned into kinetic energy the launch speed was ≈4.7 ms−1 (LCE Young's modulus E ≈ 1.3 MPa, density ρLCE = 1.16 g cm-3, and strain of 20%).
