Sentence examples for lateral rods from inspiring English sources
The adductus and cavus deformities were corrected by differential lengthening of the medial and lateral rods connecting the hindfoot and the forefoot half-rings at a rate of 3 and 1 mm/day, respectively.
The lateral rods derived from 2,5-bis p-alkoxy benzoyloxy) hydroquinone monomer gave an obvious influence on properties of the resulting polymers, in which the liquid crystalline state stability and the solubility in common organic solvents were enhanced.
After an initial period of distraction of about 5 7 days, the anterior pull-up rods are shortened differentially to correct forefoot pronation and supination, and the posterior medial and lateral rods are distracted differentially to correct the hindfoot varus or valgus.
For a single crystal of normal paraffin these lateral rods have definite cross sections that depict the crystal chain with repeat distances of c0 = 2.543 Å in the interior of orthorhombic unit cell [32].
Above the level of the lateral rod MRI results in diagnostic images (b), at the level of the lateral rod the artefact becomes too marked (c).
In this example, two posterior and one lateral rod with corresponding anchoring screws have been used (a).
Proximal and distal pins were secured to Ilizarov arches that were then connected to one another by three threaded rods that were used for further improvement of the reduction in frontal plane (using the lateral rod) or in the sagittal plane (using the anterior and posterior rods, Fig. 4).
Both half rings are connected together by medial and lateral connecting rods acting as motors with universal or bi-planar hinges.
The mass on the back was attached to the participant through two different harness mechanisms: a basic harness design (as seen on college student backpacks) and a more advanced design containing lateral stiffness rods and a weight-bearing hip belt (as seen on backpacks for hikers).
The mixed three-node beam finite elements are employed to model the longitudinal and lateral deformation of rods.
The method is based on the uniaxial tension of a slender metal rod, with the lateral surface of the rod being under well-defined thermal boundary conditions.
