Sentence examples for large slippage from inspiring English sources

Aimed at controlling the large slippage deformation of the two sides, serious deformation and failure in the corners of the two sides and massive bolt breakage, a "controlling and yielding coupling support" control technology is proposed.

Commonly used speed-lock connection exists large slippage and low energy dissipation capacity, new speed-lock connections with additional bolts (and welds) are investigated in order to enhance its performance.

These large burrs and chippings were found to be induced by large slippages that are unique to amorphous alloys.

As (-h_s) and (h_{tau 1cdots 12}) become larger, slippage avoidance and energy saving are further enhanced, respectively.

The epicenter of the quake (denoted with a star, above) was located about 400 kilometers southwest of the magnitude-9.1, tsunami-spawning temblor that occurred off the northwestern coast of Sumatra on 26 December 2004 (areas affected by largest slippage of that quake are depicted in red, orange, and yellow at upper right; northwestern tip of Sumatra depicted in gray silhouette).

Moreover, Santa Maria has experienced considerable volcanic and land-surface disturbance, with large scale slippage events dumping significant parts of the island back into the sea at intervals [ 19].

Other authors have reported that for tight gas sandstones the slope decreases with increasing net stress (e.g., Sampath and Keighin 1982; Rushing et al. 2003), and we find this in most of the samples; however, for sample KTF an increase in the slope can be observed, due to the proportionally large reduction in slippage radius as calculated from slip parameters (Fig. 9).

Removal of TE sequences via both small deletions mediated by replication slippage and larger deletions mediated by ectopic recombination between TE copies is a critical component of TE dynamics that clearly impacts genome size evolution (Petrov 2002; Bennetzen et al. 2005).

A marked transition in mutability was observed as the repeat array lengthened, such that slippage rates at large repeat numbers were significantly higher than the background rates.

Recombination between large intergenic regions or replication slippage could also contribute to expansion of low complexity sequence (Bzymek and Lovett 2001; Viguera et al. 2001; Yang et al. 2008).

The higher mutability in longer alleles can be explained by stabilization patterns concerning the mismatch-repair system, which may be less effective and as a result generate a relatively large probability for insertion of slippage events if the repeated region is sufficiently long, as suggested by Wierdl et al. [ 32].