Sentence examples for lap method from inspiring English sources

Finite-element evaluations of the internal stresses in laminates, joined in both the conventional lap method and the new manner, suggest that the proposed load-transfer mechanism may improve joint efficiency by substantially increasing the size of adhesively bonded areas, and by making the stresses in the adherends nearly uniform through the thickness of the laminate.

The water-ethanol procedure recommended in the NREL LAP method was primarily developed with agricultural residues in mind [ 32].

For all compositional analyses, the NREL LAP method [ 53] for sample preparation was followed in accordance to methods used for softwood feedstocks, unless otherwise specified.

This initial "Klason based method" was followed by the full NREL LAP method where the extractives were first quantified by a standard "water followed by ethanol" extraction prior to acid hydrolysis.

Writing in the Thursday issue of Science, the four engineers report that the cat's lapping method depends on its instinctive ability to calculate the point at which gravitational force would overcome inertia and cause the water to fall.

The experimental results showed that the new lapping method could adequately predict the effective diameter and error on travel by observing the lapping torque.

This paper presents a new lapping method to determine the technical and operational feasibility of a prototyped lapping tool with the combination of a flexible lap and polyurethane elastomer which can be mounted in the vertical-type automatic lapping machine.

This paper experimentally studied the bond behavior of carbon fiber reinforced FRPs (CFRP -to-steel joints through a single-shear lap testing method.

Shear strength of the adhesives and polymer films was usually measured by lap shear test method.

Based on the experimental observations on the lapped connection tests where combined bending and shear is always critical in the cross-sections at the end of laps, an analysis method is proposed to evaluate all the internal forces within the lapped connections.

The bonding of polystyrene (PS) surfaces below Tg was investigated by two different fracture tests: the lap-shear joint method and the cantilever beam method.