Sentence examples for laboratory chamber from inspiring English sources

VOCs deposit on material surfaces is also reported by the literature where sorption processes are described through laboratory chamber testings [20, 21].

However, field chamber experimental design may affect the magnitude of the fluxes measured, and the laboratory chamber only provides a minimum estimate of flux.

Experiments for formation of secondary organic aerosol (SOA) from photooxidation of 1,3,5-trimethylbenzene in the CH3ONO/NO/air mixture were carried out in the laboratory chamber.

We obtained sorption isotherms for phthalates on different interior surfaces from data collected in a residential field study and a laboratory chamber study (Xu et al. 2009).

All mice were therefore tested for grooming behavior in 2 environmental contexts: 1) a standard behavioral neuroscience laboratory chamber, and 2) their own home cages (a relatively stress-free environment).

Several emissions studies conducted in laboratory chambers have suggested that ingredients in cleaning products such as glycol ethers are slowly released in the air even hours after product applications [ 17, 18].

Films obtained by bi-axial extrusion were exposed in a laboratory weathering chamber for periods of up to ∼1100 h of irradiation.

A typical laboratory puffer chamber geometry has been extracted from the published literature and generated multi-block structured grid using Altair's HyperMesh software.

These findings have largely originated from laboratory scale chamber experiments, with several studies drawing different conclusions regarding the primary VOC removal mechanism, and removal efficiencies.

Tetrachloroethylene (PCE) was released into a two-dimensional laboratory flow chamber packed with water-saturated sand which was then flushed with a surfactant solution (2% Tween 80) until all of the PCE had been dissolved.

This paper presents experimental results using a laboratory water chamber, wherein the fundamental parameters of an oscillating water column (OWC) system's geometrical design are individually investigated and optimized for maximum amplification factor of wave energy to mechanically useful energy.