Sentence examples for joint surface area from inspiring English sources
The models were manually colored: yellow was choose for the bone, red color lines were painted along the fractured fragments and white color was distributed over the joint surface area (where visible) (Fig. 1) under the supervision of a radiologist.
Studies of bone allometry typically use simple measurements taken in a small number of locations per bone; often the midshaft diameter or joint surface area is compared to body mass or bone length.
This was independent of other factors with the exception of pain and joint surface area, suggesting these three factors are all linked.
Chondral defects, cartilage volume and joint surface area was determined at the patella, medial and lateral tibial compartments of the right knee by quantitative magnetic resonance imaging.
This construction for defining the centre was chosen such that the reference point disregards the cartilaginous joint surface area of the metatarsal head and could also be identified on post-operative x-ray images after removal of the medial exostosis.
The reference point construction disregards the cartilaginous joint surface area on the metatarsal head and therefore can also be identified on postoperative x-ray images after removal of the medial exostosis.
Scaling exponents for humeral (a = 1.34) and femoral (a = 1.26) head radii versus length were greater than 1, indicating that the shoulder and hip joint surface areas increase allometrically with increasing body size.
The coracoid acts as a bone block and increases the joint surface contact area.
The Latarjet mechanism of stability is twofold: Open image in new window Fig. 14 Schematic representations of surgical treatment of shoulder anterior instability: Bankart (a) and Latarjet (b) procedures The coracoid acts as a bone block and increases the joint surface contact area.
The ankle is a highly congruent joint with a surface area of 11 13 cm2.
For this data set, the linear correlation coefficient R is 0.46, 0.51, 0.67, and 0.72 for particle number, joint length, "geometric" surface area, and S BET, respectively.
