Sentence examples for joint layer from inspiring English sources

This is presumed to occur because the thermal resistance decreases in the heatsink much more than it increases in the joint layer, owing to the increased uniformity of thermal spreading as the joint-layer thickness increases to the optimal value.

This effect of thermal resistance reduction with thickening of the joint layer is seen when the thermal conductivity of the joint layer is sufficiently higher than that of the heatsink and the area of the joint layer is sufficiently smaller than that of the heatsink.

The multiple reaction leads to a compact joint layer with a very low porosity, in contrast to joints formed only by a formation reaction.

Therefore the multiplication (10) was replaced by division operator in fractions of compound terms (11)(12)(13) without an negative effect, reducing the combination degree of composite term polynomials each previous joint layer.

This study reveals that the design concept for power modules should change to preliminarily estimate the optimal thickness to achieve the minimum thermal resistance when the thermal conductivity of the joint layer is much higher than that of the heatsink.

In the case of a 100 nm Ti coating as an interlayer, the C concentration in the joint layer was saturated quickly, which benefited the formation of a TiC phase and subsequent Ti3SiC2 phase.

Following this inter-intine cohesion, additional deposition of sporopollenin with a joint layering of the four microspores further strengthened this connection.

The device assembly steps included integration of the control PDMS layer (thickness ∼5 mm) on another thin PDMS layer (thickness ∼1 mm) containing eight microchannels with microcups followed by assembling the joint layers of PDMS with microfabricated Au electrodes.

In 1995, a joint-layer optimization perspective was proposed by Telatar and Gallager in [7].

As structural defects, full and empty joints, layered structures and larger air voids were considered.

However, these techniques can only be efficiently applied to ad hoc networks when they are part of a joint physical layer (PHY) and Medium Access Control MACcross-layeryer design (CLD).