In finding the design point it is required to find the response and its sensitivity with direct differentiation method, this is the most challenging part of TELM, thus developing the sensitivity analysis for using the other material models is necessary.
More investigations are needed to further generalize TELM; some of these have been listed below: In finding the design point it is required to find the response and its sensitivity with direct differentiation method, this is the most challenging part of TELM, thus developing the sensitivity analysis for using the other material models is necessary.
Therefore, it is required to find the suitable value of its exponent through measurements.
So it is required to find an optimal one to obtain the highest oil recovery.
It is required to find and use new opportunities in the new product development process.
It is required to find all signals (Si + Sj) that are larger than a given signal (Sg).
To predict, it is required to find the mathematical relation between the input and output data by an accurate and simple method.
In most of these studies, it is required to find a relation between two transmitted signals to perform PNC mapping at the relay node.
This is due to the fact that for the construction of other dynamic parameters, it is required to find the inverse transformations for Eq. (7).
In order to commence the iteration process, it is required to find the initial solution vector (c^{0}=[c_{-1}^{0},c_{0}^{0}, ldots, c_{N+1}^{0}]^{T}).
To make matching feasible, it is required to find out which images may see the same scene without doing full expensive matching.
