Sentence examples for isolated surface from inspiring English sources

b The isolated surface II slab obtained from cleaving at the termination II planes.

purple hydroxide with three Fe neighbors, green O2− with three Fe neighbors, blue hydroxide with two Fe neighbors Fig. 4 a The isolated surface ID slab obtained from cleaving at the termination I planes shown if Fig. 2a.

In addition, the new method is applied to the simulation of the receptivity process of a Mach 5.92 flow over a flat plate under the combined effect of an isolated surface roughness element and surface blow and suction.

We can rule out isolated surface Mn and deep-trap emission since distorted ligand/crystal field at the surface causes isolated Mn PL peak wavelength shift to only ~620 nm [6, 53], and the same synthesis without Mn leads to mainly band-edge emission with a weak deep-trap emission between 450 and 550 nm when observable (Additional file 1: Figure S2), respectively.

As it moved into the Gulf of Mexico, a weak and isolated surface low pressure area formed off the coast of Louisiana.

For controls, we isolated surface epithelial cells (OSE) from the normal (noncancerous) ovaries of 12 individuals including matched sets of samples of OSE and normal stroma (NS) from 8 of these patients.

The silt-plus-clay fraction (fines) on these isolated surfaces is closely alike in magnetic-mineral composition, in contrast to greatly dissimilar magnetic compositions of rock surfaces of vastly different lithologies, on which the fines have accumulated.

Further, we never observed the nucleation of a new actin filament from an isolated surface-tethered diVCA-Arp2/3 complex, consistent with previous conclusions that Arp2/3 complex cannot nucleate a daughter unless it is bound to a pre-existing mother filament (Machesky et al., 1999; Blanchoin et al., 2000; Achard et al., 2010).

Glass beads were tested to isolate surface roughness effects from other shape effects.

The role of Au is to isolate surface Pd atoms into Pd monomeric sites thereby enhancing the VA formation rate and selectivity.

We seek to isolate surface contributions to secondary nucleation by designing protein templates that display the residues that are found on the IAPP20 29 fiber surface without displaying IAPP20 29 fiber ends.