Sentence examples for is applied in a process from inspiring English sources

If sufficient pressure is applied, in a process called reverse osmosis, clean water emerges on the other side of the membrane.But reverse osmosis, though less energy-intensive than thermal evaporation, still requires a lot of electricity and maintenance.

If sufficient pressure is applied, in a process called reverse osmosis, clean water emerges on the other side of the membrane.But reverse osmosis, though less energy-intensive than thermal evaporation, still requires a lot of energy, and can deal only with relatively low salinities, like that of seawater, which has a salt content of around 3.5%.

The proposed method, based on the above assumptions, is applied in a five step process carried out by a multidisciplinary panel of experts.

These guidelines and additional new design hypotheses were applied in a design process - a "research by design" and tested further through microclimate simulations.

The Haling Power Distribution (HPD) has been applied in a unique process to greatly accelerate the in-core fuel management optimization calculations.

The dual initiator has been applied in a sequential process to prepare well-defined block copolymers of poly methyl vinyl ether) (PMVE) and hydrolizable poly tert-butyl acrylate) (poly tert-butylhyl acrylate) (PtBA or poly methyl (PS) by living cacrylatePMAymerizatior and atom transfer radical polystyreneion (ATRPS, respectively.

Fruit hull of 9.52% solid loading pretreated at optimum conditions (0.9% sulfuric acid, 178°C, 30 min) was applied in a SSF process using S. cerevisiae at 37°C.

In reality, there is no single answer since the selection of Design Patterns that can be applied in a design process depends primarily on the subjective opinion of the designer, and it is based on which design patterns better match the design requirements.

The surface coating, composed mainly of nickel and chromium, was applied in a two step process: plasma spray followed by laser surface alloying using a diode laser.

For validation of the study, the proposed method was applied in a plastic molding process as a real case and the results were compared and analyzed.

For instance, the Level 3 check might be applied in a timed, batch process rather than immediately when a new observation is acquired.