Sentence examples for is acceptably small from inspiring English sources
Our results indicate an intermediate parameter range where the error is acceptably small.
The sensor is about as big as a portable hard drive and the base station is acceptably small enough, although the fact that it screams at you when things change in the system might be a giveaway to thieves.
The stochastic differential equation (1) can be discretized and approximated by S_{t+1}=e^{-lambdaDelta t} S_{t}+ bigl 1-e^{-lambdaDelta t}bigl 1-e^{-lambdaDeltac{(1-e^{-2lambigl 1-e^{-lambdaDeltada}} Delt}bigrt}, (2) where Δt is acceptably smu+sigmasqrtelta W_{frac{ 1-e^{-2lambdatriangleally distributed Wiener process.
We chose to set the standard SIP size to six words because it represents the smallest possible sentence size for which the average count is acceptably small (22 versus 109 for 5-word sentences).
The German translation of the DEMMI is a valid measure of the mobility of older individuals in sub-acute geriatric inpatient care and measurement error between two physiotherapists is acceptably small.
The model for the repeated attempts has enabled us to identify the effect of the trial outcome in the missing data model because the standard error of β ^ 2 is acceptably small.
The conservatism is shown to be acceptably small from a user's point of view.
The procedure described in the paper uses the Hardy Cross method of balancing flows at network nodes until errors throughout the network are acceptably small.
While (e_t^{varvec{varLambda}}) may be acceptably small while the changes in injected power vary minimally, however if the network state changes significantly then the central coordinator can recalculate and redistribute relevant portions of the sensitivity matrix.
We found that the error in using this approach, compared with that of the usual implementation of the TCD (Point Method) was acceptably small (less than 20%) in the great majority of cases.
Heat transfer measurements show that the redistribution of water to form an additional lower viscosity carrier layer while increasing the solids concentration of the upper layer or layers enables the maximum drying rate, for which drying-air induced surface disturbances are acceptably small, to be increased with significant commercial benefits.
