Sentence examples for iron shaft from inspiring English sources

The tribological properties of the DLC film were then investigated, by conducting a rotational friction test of the DLC coated tube against a cast iron shaft under dry condition; as a result, the minimum friction coefficient of 0.17 was obtained at the position 40 mm distant from the bottom end of the tube where microwaves are injected during deposition.

An iron shaft fixed in the center of the kiosque traverses it from bottom to top, and the lower end of this works in an iron plate, whilst the upper end bears on strong supports in the roof of the edifice which contains this pavilion.

Then, continue wrapping the hair down the curling iron shaft, leaving a little bit of space between each wrap.

In general, people with faster swings prefer stiff shafts on their woods and iron shafts on the irons.

He introduced cast-iron shafts and gearing into windmills and water mills, receiving the Royal Society's Copley Medal for An Experimental Enquiry Concerning the Natural Powers of Water and Wind to Turn Mills (1759).

At this stage he also puts eight sides (or "flats") on to a short section of each iron's shaft.

The contract, Fairbairn's first as a millwright, involved the replacement of line shafting in the complex, with wrought iron line-shafting designed to work at higher speeds.

Then Bismillah sold them a putting iron with a shaft that was slightly bent.

3.48pm: We're on the fifth and Norman and Choi both hit sublime shots into the green - Norman holding a five iron down the shaft and chopping the ball 150 or so yards low towards the flag, which illustrates how windy it is.

Flow of a gas solid two-phase mixture through a packed bed is relevant to a number of industrial processes such as heat recovery and filtration of dusty flue gases, iron making in shaft reactors, gas purification, and sorption enhanced reaction processes.

The main driving shaft of iron, with its cylindrical necks supported on iron crescent-shaped bearings, ended in a pinion which engaged a gear wheel at the lower end of the main vertical transmission shaft.