Sentence examples for introduction of segments from inspiring English sources

This review article provides an overview of how the introduction of segments containing inorganic elements into block copolymers can help to address these issues and can also allow the direct deposition of functional materials such as metal nanoparticles.

Studies on the Tfp of the related pathogen Neisseria gonorrhoeae have revealed that changes in the amino acid sequence of PilE (pilin), the major subunit of Tfp, arise through introduction of segments of non-expressed pilS cassettes into the pilE expression locus by a unidirectional DNA recombination event known as gene conversion [ 8, 9].

The results show that: (1) the hard-segmented copolymer could be employed as a crystal modifier of calcite; and (2) the introduction of soft segments into the hard-segmented backbone could prohibit the phase transformation of vaterite to calcite, depending upon the structure and the concentration of the synthesized copolymers.

The introduction of PEGMA segments promoted the migration of low surface energy PHFBM segments to the surface of the membrane.

Furthermore, due to the introduction of soft segments (BA and BS) into BT crystal lattice, melting temperature of PBTSA fibers (115 °C) was over 100 °C lower than that of PBT.

Weight loss data showed that the introduction of PEG segments to the PCL main chain did not alter the enzymatic degradation of PCL significantly.

It is thus not surprising that the introduction of short segments between genes could impair fitness, but the expectation now is that the effects of most individual insertions should not be large.

The development of this methodology allows successive and, in principle, limitless introduction of arm segment into μ-star polymers.

The results indicated that the introduction of PBSe segment not only significantly enhanced the crystallization rate of PBC, but also displayed the same crystallization mechanism within the investigated crystallization temperature range despite of the variation of the PBSe segment content.

Compared with corresponding PF homopolymers, the EL devices based on PF-PTPA block copolymers showed higher luminance and current efficiency than those of PF homopolymers because of the improvement of hole injection by the introduction of PTPA segment.

Furthermore, the introduction of aliphatic segment a hexane-1,6-diamine (HDA) in copolymer led to a significant increase in proton conductivity and water uptake with increasing temperature; the proton conductivity of the Ic-70 membrane reached 0.212 S cm−1 at 80 °C, which was higher than Nafion 117 as well as of the membranes based on aromatic diamines at equivalent IEC values.