Sentence examples for intermediate coefficient of from inspiring English sources

Key characteristics of the resulting thin film are: (1) controlled intermediate coefficient of friction and (2) positive friction, to reduce roll slip oscillations related to both curve squeal noise and short pitch corrugation development.

Native mcfp-1/HA coacervates had an intermediate coefficient of friction (μ ∼0.3) but conferred excellent wear protection to mica with no damage from applied loads, F⊥, as high as 300 mN (pressure, P, > 2 MPa).

The RCOT model replaces the familiar square matrices A (the matrix of intermediate coefficients per unit of output) and I (the identity matrix) by rectangular matrices, A ∗ and I ∗.

This is reflected in D. pseudoobscura's intermediate Gini coefficient of approximately 0.50, or about 80% of recombination occurring in 50% of the sequence (fig. 3).

At intermediate polymer coating thicknesses, the coefficient of friction was found to be substantially independent of the wax level.

Intra-operator and intermediate precision, expressed as the coefficient of variation (%CV), were high at 10.5 15.5%CV and 13.5 14.5%CV respectively.

The most influential parameters affecting the simulation of soil nitrate content, mineralization, denitrification, nitrate leaching and plant nitrogen uptake were the transient coefficient of fast to intermediate humus pool, the carbon to nitrogen ratio of the fast humus pool, the organic matter decay rate in fast humus pool, and field capacity.

Within-day and between-day precisions (coefficient of variation: CV) for low, intermediate, and high concentrations of the different curves were below 15%.

Furthermore, the friction coefficient of Cr B/Cr B-N multilayer exhibited an intermediate value of ∼0.45 between those of Cr B/Cr B-Nand Cr–B–N (0.2).

The figure shows that the regularity of the dynamics is maximum (the coefficient of variation is minimum) for an intermediate noise level.

The analysis also predicted that inserting a material of an intermediate expansion coefficient between the film and epoxy undercoat should reduce the residual stress.