Sentence examples for interface shows that from inspiring English sources

The rheological behavior of composite SPI HMP solutions at the air water interface shows that the HMP addition increases the elastic interfacial modulus.

The surface roughnesses at the substratelfilm and the film/air interface were significantly different, \(\sim\ 4 and \(\sim\ 13 Å, respectively, but even the larger number for the film/air interface shows that continuous and molecularly smooth layers are formed.

SEM observation on the interface shows that the adhesion between PA1010 and pure PP is very weak and their interface boundary is sharp.

Comparison between a microslip and a macroslip model for the friction interface shows that the macroslip model gets close to predicting the optimal weight, but the response level is much higher than when the microslip model was used.

Comparison of the results with a model based on capillary pressure equilibrium at the poultice/substrate interface shows that the accumulation of salt from the substrate in the poultice may improve the salt extraction process, because the osmotic pressure decreases the effective pore size of the poultice.

The band structure of the interface shows that the bands of graphene layer are open with a 0.13-eV gap at the K point.

Measuring the interlayer distances in the vicinity of the MoS2 CNT interface showed, that deposited particles typically contain 1 3 (rarely, up to 10) MoS2 layers, which are in close contact with graphitic CNT walls.

During charging, the lithium peroxide particles shrink beginning at the nanotube-peroxide interface, showing that oxidation occurs where it is easiest to remove electrons.

The microstructure scanning electron microscope (SEM) photos of the concrete near the rebar concrete interface showed that a loose structure with larger microvoids existed in the interface zone.

Utilizing confocal Raman mapping, we collected spectra at the fibre-droplet interface, showing that lipid-specific peaks appear concentrated in the droplet, whereas total organic and protein-specific peaks are more evenly distributed (Fig. 3f).

Experimental results and post-failure inspection of the fiber matrix interface showed that the new test method is effective in measuring high rate interface properties of composites.