Sentence examples for integrated decay from inspiring English sources

Results indicated that the long-term integrated decay heat load (IDHLL) and the short-term integrated decay heat load (IDHLS) can be effectively used to represent the repository capacity impact for SNFs and HLWs, respectively.

The method is based on the use of integrated decay heat load (IDHL) limits.

The derived integrated decay heat loads were found to appropriately represent the drift wall temperature limit (200 °C) and the midway between adjacent drifts temperature limit (96 °C) under the high temperature operating mode as long as the wastes are uniformly loaded into the repository.

The normalized integrated decay intensity was plotted against the excitation wavelength (i.e., central wavelength of the envelope) to give the two-photon phosphorescence brightness spectrum.

Moreover, as shown in the emission spectrum (typical spectrum of PP was presented in Figure 4) recorded in the range from 1250 to 1300 nm with the same equipment using a monochromator (the intensity was obtained by integrating decay profile from around 2 to 8  μs), the spectral shape with a peak maximum at around 1271 nm is similar to that for singlet oxygen as reported in the literature [ 20].

We seamlessly integrate weight decay with traditional synaptic plasticity and modulate the leak rate using the temporal dynamics of pre- and post-synaptic neurons to realize habituation.

mRNA translation is known to be tightly integrated with mRNA decay.

As discussed above, the brief and successive display of dots allows for recognition to the extent that the information can be integrated before it decays.

Excitation gates (5000 10000) were averaged to obtain a decay, whose integrated intensity was normalized by (i) the overlap integral of the emission spectrum of the sample, quantum efficiency spectrum of the detector and the transmission spectra of the filters; (ii) concentration of the sample; (iii) the square of the refractive index of the solvent; and (iv) the square of the excitation flux.

The corresponding FLIM image of Figure  1a and the associated emission decay features integrated for all pixels of channels 1 and 2 are presented in Figure  1b.

The total decay features integrated for all pixels of the FLIM image (see Figure  2) produce good statistics for reliable mean values of τ1 and τ2, which would overcome the strong spreading of these quantities due to the disorder introduced by the treatments.