Sentence examples for insulated side from inspiring English sources

The FGM layer gradually transits material phases from well-conductive side (with aluminum dominated) to another highly insulated side (with HDPE).

In the case with insulated side walls, the heat transfer rate from the heated bottom wall or top cooled wall increased as each of the side walls was replaced by a cooled or heated side wall.

When pinpointed on a satellite image, Cherry Springs is in the middle of an uncharacteristically dark patch – insulated, on all sides, by hundreds of thousands of acres of protected forest and perched atop the Allegheny Plateau, 700 metres (2,300 feet) above sea level.

Install the circuit breaker into the panel by first hooking or clipping to the grounded or insulated slot or rail (manufacturer dependent) on the outboard side of the insulated electrical contacts, then line up the clip or slot of the circuit breaker with the electrical contact rail or bus.

Electrochemical drilling uses a side-insulated tube as the tool cathode and removes anodic material via controlled electrochemical reactions in a cell.

In general, the introduction of inner insulation layer can distinctly reduce the pressurant gas requirement in the pressurized discharge process of cryogenic tanks, and the two-side-insulated tank technique may be an alternative technique in the design of pressurization system.

In the present paper, a two-side-insulated tank, in which both of interior and outside surfaces of the tank wall are covered by insulation layers, is proposed, and a computational fluid dynamic (CFD) approach is introduced to investigate its thermal behaviors and pressurization performance.

There's nothing too fussy here, just usefully-big pockets (including insulated bottle pockets at the side) and a change mat.

And to avoid losing heat during the winter, the fan should be covered with an insulated cover on the attic side.

Cladding of either side of an insulated block joint greatly improves its lipping resistance and allows it to withstand approximately 3 times the energy input into the contact compared to a standard un-clad IBJ.

TTFields were generated between liquid metals plus inserted (intradermal) wholly insulated wire needle placed on one side of the tumor and inserted (intradermal) wholly insulated wire needle placed on the other side of the tumor.