Sentence examples for insufficient load from inspiring English sources

than individual CNTs due to the weak interfacial shear strength between adjacent shells, nanotubes, and nanotube bundles, causing insufficient load transfer.

FWD test results for all three projects yielded much higher deflections than the target design deflections, indicating insufficient load bearing capacity.

Directly spun CNT fibers, however, generally include amorphous carbon and weak shear interaction between tubes or bundles, thereby causing insufficient load transfer.

In addition to the global budgetary constraint, the optimization is also conditioned on local constraints imposed on traffic flow by insufficient load carrying capacity of deficient bridges.

The insufficient load demand of MG2 is supplied by the generation of CHP2, curtailing load through DR and purchasing power from MG3. 3) DR. During the scheduling, each MG can opt to curtail load with a comprehensive consideration of the resources of the supply side and the demand side.

Genome sequencing of paramyxovirus-positive rectal samples by 454 pyrosequencing failed to amplify paramyxovirus sequences, probably because of insufficient load of viral RNA in the sample.

We found the interfacial carbon film between the CR3 coating and steel substrate, which caused poor bonding and consequently insufficient load-bearing capability of the coating.

However, insufficient load-bearing capability and a high rate of intraoral wound dehiscence were found in the majority of the study animals.

However, during the melt season, there was no diurnal change in water pressure; however, the high water pressure conditions may have been ideal for icequakes during the morning (Stage 4) and evening (Stage 2), whilst the during the early morning (Stage 3) and the slip phase (Stage 1) there was insufficient loading for icequakes to occur.

The evolutionary solution to these fundamental problems is the process of bone remodeling in concert with the ability of osteocytes to sense both insufficient loading and mechanical damage caused by overloading, and to activate remodeling to correct the resulting problems.

The results show that the alloy steel bar used for the half-shaft did not follow specifications, with a consequent lower strength and resulting in a material with insufficient loading capacity and fatigue resistance.