Sentence examples for insufficient adhesion from inspiring English sources
The laser-acoustic method yields the Young's modulus, revealing the effect of varying bonding structure of the material, porosity and other micro-defects, including insufficient adhesion.
A common distress type of chip seals is scabbing (loss of aggregate) which is caused by insufficient adhesion between aggregate and binder.
Based on the experimental results, it was found that the tensile strength of GFPP was decreased in the higher cooling rate due to the insufficient adhesion strength between the glass fiber and PP.
Insufficient adhesion between the membrane and substrate, mask corrugation, and general transfer problems reduce the reproducibility and uniformity of the fabricated structures.
When EPD layers of Pt NPs without vacuum annealing were observed by contact-mode AFM, it was discovered that the NPs were shifted by the AFM stylus and no reproducible image was obtained, showing insufficient adhesion of NPs to the wafer surface.
The same BIS sensor was used for the entire period, unless an insufficient adhesion required a sensor replacement.
The insufficient bond adhesion may increase the transferred stresses and extended strains in the relevant layers when applied to traffic.
Limitations are often associated with these approaches such as improper scaffold stability, and insufficient cell adhesion, proliferation, differentiation, and mineralization with less growth factor expression.
Despite the superior tribological and mechanical properties, the advantages of diamond-coated tools, however, have been largely compromised by the insufficient coating substrate adhesion.
As a result, poor interfacial adhesion, insufficient dispersion, and non-uniform distribution are observed.
