Sentence examples for inserts surface from inspiring English sources

Considering the inserts' surface micro-structure and mechanical properties developed after the laser treatment, the coated tools' cutting performance deterioration or improvement compared to untreated substrates was explained.

Briefly, astrocytes were seeded (3 × 10 cells/cm) on the bottom of collagen-coated Transwell inserts (surface area: 0.33 cm, pore size: 0.4  μm, Corning Incorporated, Corning, NY, USA) or 24-well plates 2 days before the bEnd.3 cells were seeded (4 × 10 cells/cm) inside the insert, on the upside of the membrane, and cultured to tight monolayers.

This study of 55 early-generation acetabular inserts found that severe wear of the convex insert surface correlates with osteolysis.

To visualize femorotibial contact, the proximity between surfaces of femoral component and tibial insert was calculated, and mapped onto the insert surface model.

Wear of the concave insert surface did not correlate strongly with osteolysis probably owing to prevalent micromotion and wear at the convex surface interface.

In cementless acetabular arthroplasty, the interface between the metal backing and the ultra high-molecular-weight polyethylene acetabultra high-molecular-weighttential soultra high-molecular-weight.

All the attempts regarding modification of the insert surface preparation, nature or geometry did not improve the behavior of such anodes used in severe cyclic pressure conditions.

The Fish Scale (FS) profile is introduced on the insert surface to improve the convective heat transfer coefficient, for a constant heat transfer area.

The Inverted Fish Scale profile is introduced on the insert surface, so as to improve heat transfer through increasing the convective heat transfer coefficient of the flow, for a constant heat transfer area.

Although concern over linear wear predominates with contemporary designs, if initial liner engagement is compromised or locking mechanism failure occurs with time, the convex insert surface again may become a significant source of debris contributing to osteolysis.

According to the results of material removal analysis, the polishing path was planned by dividing the mold insert surface into 5 zones to ensure abrasive flow direction perpendicular to the side of microstructures.