Sentence examples for insertion temperature from inspiring English sources

The graphical presentation of the results is facilitated by the insertion at each multiple-utility temperature a perturbed temperature equals the insertion temperature minus a small perturbation.

This implies that the nitrogen diffusion is decoupled from nitrogen insertion at constant temperature for sufficiently high nitrogen supply.

Lattice expansion in austenitic stainless steel after nitrogen insertion in the temperature range between 320 and 380 °C is a well established phenomena whereas conflicting data on the existence of expanded phases in martensitic stainless steels are published.

In addition, the structural effects associated with metal insertion at room temperature were evaluated.

Fig. 6 Core-tube-unit at 130 °C with loose fit. Figure 4 shows an opening for insertion of a temperature sensor.

The strategy is based on mid-point insertions at the temperature gaps where the exchange rate is most compromised.

Suppression of threading dislocation densities due to lattice mismatch and thermal expansion coefficient difference was achieved by the combined approach of BR superlattice insertion and low-temperature growth scheme by H-MBE.

Furthermore, the effects of co-solvents like ethanol (EtOH) on drug insertion at two temperatures and two concentrations have been studied and structure parameters and free energies obtained by means of molecular dynamics simulation have been compared.

We found that pre-warming the SLIPA results in a higher OLP than the previous method of room-temperature insertion for up to 3 min. With faster sealing, a more reliable positive pressure ventilation is available, and the risk of aspiration can be further reduced.

The time in the oven was noted from the point of insertion, with the reactor temperature following a ballistic heating profile, from ambient to the oven air temperature, as measured separately by a thermocouple probe.

In one method, the SLIPA was kept at room temperature before insertion, and in the other, the SLIPA was pre-warmed to body temperature (37 ° C) before insertion.