Sentence examples for insertion of the sample from inspiring English sources

When a hydrogenation reaction is carried out with gaseous hydrogen enriched in its para- isomer in the earth magnetic field (prior to adiabatic insertion of the sample in the NMR magnet), enhanced proton longitudinal order (represented by 2IAzIBz) is created but also difference of enhanced polarizations (IAz−IBz).

Both transmission and PL are monitored prior to the insertion of the sample and appropriate care is taken to avoid any solvent turbulence during the insertion.

The NMR tube was sealed with a rubber septum and purged with nitrogen gas for 30 min. An initial NMR was taken at room temperature, then the probe was heated to 70 °C, locked, and shimmed on a dummy sample before the insertion of the sample tube.

Kinetic model computations show that worst-case disturbances to the measured temperature field, which may be caused by the insertion of the sampling cone into the flame, do not alter mechanistic conclusions provided by the kinetic model.

Open image in new window Figure 10 Low voltage (100 V) SEM- images of the coated weft insertion of the samples: a-b) with coating A and c-d) with coating B. It is relevant to compare the top view mapping of the samples in Figures 9 and 10 with the distribution of the coatings showed in Figure 7.

Open image in new window Figure 9 SEM-images and sulphur mapping (EDS) of the coated weft insertion of the samples, top-view: a-b) with coating A and c-d) with coating B. Surface sensitive imaging was performed with low voltage SEM, illustrated in Figure 10a-b for coating A and 10c-d for coating B, in order to better distinguish the coatings from the textile substrate.

Two days after insertion of the probe, sampling started at 0900 h and continued for 47 h.

Two days after insertion of the probes, samples were collected for 20 h as described under protocol 1.

Due to interdiffusion of the solutions during the insertion of the syringe into the sample chamber, the first injection is not useful for analysis and was omitted from all calculations.

Prior to insertion in the sample chamber of the scanning electron microscope, the ZnO thin film was coated with a thin (»100 A°) layer of Gold (Au) to avoid charging effects.

The average number of losses at these "high loss" loci was 10, which is very close to the number that would be predicted simply based on segregation of chromosomes and the probability of loss for heterozygous insertions given the sample size of sexual lines surveyed here (11.5 predicted losses when n = 46).