Sentence examples for insert volumes from inspiring English sources

Nine spherical VOIs were delineated based on the insert volumes and physical boundaries seen in the CT images.

The variation of the insert volumes from those described in [4] (shown in Table 1) reflects the physical constraints of the 3D printing technique.

Figure 2 shows close agreement between the measured VOI calibration factors and theoretical values, as defined in Eq. 7 with a FWHM of 15 mm (σ= 6.4 mm), for insert volumes >16 ml and for 99m Tc and 177Lu.

The integral under each differential DVH yields the insert volume (nominal volume 19.13 mL).

Fig. 2 cRC for A, AR and ARS methods as a function of spherical insert volume.

The cRC results for A, AR and ARS compensation combinations as a function of the insert volume are shown in Fig. 2.

The observed variation in calibration factor has been reproduced with a simple voxel level calculation over two orders of magnitude change in insert volume.

The results presented in this work are accurately reproduced with Gaussian kernel-based calculations, over two orders of magnitude change in insert volume.

The observed variation in calibration factor is reproduced using Gaussian kernel-based calculation over two orders of magnitude change in insert volume for 99m Tc and 177Lu.

Tumours of various sizes and shapes were simulated by inserting volumes with increased uptake in this mathematical phantom.

To estimate the spatial resolution of the differently processed image data and to test the stability of BF, we performed a measurement with a water-filled cylinder phantom containing six spherical inserts (volume range 0.5-26.5 mL) at a target to background ratio of 7. The phantom data were acquired in list mode using an in-house solution [10].