Sentence examples for inputs operation from inspiring English sources

Their model was used to evaluate the performance of large scale fuel reactor including the effect of variation in different inputs, operation strategies such as locations of feeding point for oxygen carriers and fuels, physical properties of oxygen carriers and fuel, and operating condition such as fluidization velocity and pressure drop.

(g the input operation of materials, evaluation report, the status of relocation and service; dossier management.

Pseudo differential pair and self-biased techniques have been used for rail-to-rail input operation of the OTA.

The proposed VFC, designed in a low-cost 0.18 μm CMOS technology supplied at 1.8 V, shows 0 1 MHz output frequency for 0 1.2 V differential input operation with nonlinearity error less than 0.4% and power consumption less than 0.4 mW.

Firstly, to obtain the I/O characteristics of amplifier, promoter-RBS components { c1,  c2} = { J6,  L3} are selected to obtain the maximum input operation range.

Firstly, to obtain the complete I/O characteristics of switching, promoter-RBS components { c1,  c2} = { J6,  L3} are selected to obtain the maximum input operation range.

In the procedure of amplifier design, the input operation range g1 ∈ [ g1, l,  g1, u ]  can be set by transforming the inducer concentration I1 into the input fluorescence according to (2) or (3) as follows Input operation range: (6) I 1 ∈ I 1, l, I 1, u ⇒ g 1 ∈ g 1, l, g 1, u a. u.

The input operation range and desired I/O response of genetic transistor are specified as follows: Input operation range: (10) I 1 ∈ 1.5 * 1 0 - 2, 4 * 10 - 2 mM ⇒ g 1 ∈ 298, 431 a. u. and (11) y d g 1 = - 2 ⋅ g 1 + 1286 where -2 is the desired amplification gain as shown in Figure  2.

The input operation range and desired I/O switch response are specified as follows: Input operation range: (14) I 1 ∈ 2 * 1 0 - 3, 10 mM ⇒ g 1 ∈ 103, 614 a. u. and (15) y d g 1 = L s + 3249.7 - L s 1 + g 1 / 150.4 2 where L s denotes the low level of switching or basal level of promoter-RBS component c3.

Note that, in the future, when the promoter-RBS libraries are large enough, the promoter-RBS components c1 and c2 can be designed and selected to match the input operation range.

Subsequently, based on our promoter-RBS libraries, the amplification gain in a specific input operation range and switching level are designed by employing GA to select the most adequate promoter-RBS components and inducer concentrations.