Sentence examples for input voltage level from inspiring English sources

The proposed converter operates successfully in soft switching operation mode for a wide range of input voltage level and the load.

DC input voltage level is determined by the inverter's specifications.

This discriminator triggers actor LEDs (basic elements 5 12) depending on the input voltage level.

For a power system, the dc input voltage level of a single-phase inverter should be greater than the peak voltage of the inverter's line-to-line AC output voltage.

A comparison is presented between a cymbal based on the original design configuration and a new cymbal, to demonstrate the effects of input voltage levels on the dynamic characteristics and vibration response of the two different transducers.

A cross-coupled charge pump is implemented in standard 0.18 µm CMOS technology using an integrated LC tank oscillator to enable a compact, low cost, self-starting solution with maximum efficiency at ultra-low input voltage levels available from embedded micro-power generators.

Our design is, currently, optimized for frequency range between 400 MHz and 1.2 GHz, and the input voltage levels in between 600 to 800 mVpp.

Lower input voltage levels result in apparent higher efficiency (i.e. close to 100%), however the transistors are operating in sub-threshold region and, therefore, the total useful power drops by orders of magnitude, which creates the additional design constrain.

Depending upon the load presented to the rectifier, the time required by the output node to reach the constant voltage level may vary between 100ns and tens of microseconds (for low input voltage levels) (Figure 14). Figure 13 Simplified schematic diagram of the three stage CMOS rectifier/charge pump.

The equivalent input voltage noise level of the ASIC preamplifier changes with the drain current of each transistor (Rhouni et al. 2013; Ozaki et al. 2014) controlled by the bias currents from the temperature-compensated BGR circuit ((I_mathrm{bias1}) and (I_mathrm{bias2})).

The peak voltage is determined by the DC voltage level input into the ADC, which corresponds to the duty cycle of the square wave output from the LM311.