Sentence examples for inner blade from inspiring English sources

All fluid was collected from the passive outflow tubing of the hysteroscope as well as from the vacuum tubing connected to the inner blade, and both measured volumes were subtracted from the measured inflow volume resulting in the fluid deficit.

respectively, where, kf is the thermal conductivity of the base fluid; q"' is the volumetric heat generation rate; Tc is the temperature at the interface of the blade and base fluid at x = L0 (L0 is the length of the building block); r0 is the radius of the inner blade; and R0 is the outer radius of the building block.

Male measurements: maximum and minimum based on n = 5 from Madagascar: HL 0.58 0.73, HW 0.78 0.94, CI 129 135, EL 0.37 0.46, SL 0.10 0.15, SI 13 16, WL 1.17 1.52, FL 0.78 1.08 Worker diagnosis: Inner blade of mandible without teeth and denticles; apical end of inner blade without a notched semicircular concavity (Fig. 2a).

Male measurements: maximum and minimum based on n = 5 from Madagascar: HL 0.85 1.89, HW 1.07 1.20, CI 122 135, EL 0.63 0.69, SL 0.20 0.22, SI 18 21, WL 1.90 1.98, FL 1.35 1.47 Worker Diagnosis Innerr blade of mandible without teeth and denticles; apical end of inner blade with notched semicircular concavity (Fig. 1a).

For the purposes of analysis, each cultured slice was divided up into four principal areas CA1, CA3, inner blade of the dentate gurus (DG/ib), and outer blade of the dentate gyrus (DG/ob).

The inner blades should be fine and evenly spread out.

Modal families are shown to transition between system, inner-blade, and outer-blade motion.

friederichsi Forel, 1918 pattersoni sp. nov. Key to workers and queens of Malagasy Anochetus Inner mandibular blade without preapical teeth and denticles (Figs 3a, 4a).2 Inner mandibular blade with at least four preapical teeth and denticles (Figs 2a,e).4 Worker compound eye large, >0.15 mm long.

In this concept, each time the user runs the taps, the water flow shall initiate the system by moving the inner mini blades and convert rotational motion to the shaft, which links to the DC generator.

In wind tunnel experiments, in order to investigate flow visualization, light-weight tufts attached to the inner surface of blade are used to gain insight on the flow characteristics of VAWT during rotation in the low Reynolds numbers.

Through adjusting wind direction, the tower cowling can make more wind forcing on the inner part of blades which produce positive torque, and prevent wind from forcing on outer part of blades which produce negative torque.