Sentence examples for inlet was obtained from inspiring English sources
To quantify the degree of mixing for a location in 3D microchannels, the standard deviation of the normalized fluorescence intensity, i.e. fluorescence intensity at a location with respect to the maximum fluorescence intensity at the inlet, was obtained from cross-sectional confocal microscopy images using (sigma = langle (I - langle Irangle )^{2} rangle^{1/2}).
A local unstart of hypersonic inlet is obtained with the initial backpressure and temperature of test section equal to the hypersonic freestream static pressure and static temperature, respectively.
Increasing the CO flow reduced the width of the particle distribution curve where an optimum inlet gas flow was obtained at 25.5 mL/min (Figure 2B).
The maximum extent of degradation of diclofenac sodium was obtained at inlet fluid pressure of 3 bar and initial pH as 4 using hydrodynamic cavitation alone.
The results showed that the growth rate agreed well with Hsu's experimental data under the combination kinetic models of Hogness's homogenous and Furusawa's heterogeneous ones, in which a complete silane decomposition was almost achieved, but the impractical growth result was obtained as inlet silane mole fraction higher than 0.5.
The highest absorption rate was obtained with an inlet concentration of acid of 46·6 wt%.
Under this condition, similar regular square wave in the inlet and outlet of the reactor was obtained to guarantee the reliability of the dynamic OSC results.
An entrance length of 50 80D (or 90 170D) was obtained for normal inlet slug length distributions centred on 2 5D (or 2 6D), for superficial gas and liquid velocities up to 0.40 and 0.30 m/s, respectively.
The performance of the present collector with optimum number of thermosyphon tubes was compared with the performance of two-phase closed thermosyphon flat-plate solar collectors with tube in tube heat exchangers of previous investigators and a better performance for the present collector was obtained at high inlet water temperature.
By contrast, the maximum diesel yield was obtained at about 5 m above the feed inlet, and the yield of light oil achieved the maximum level at around 10 m above the feed inlet.
Fazaelipoor and Shojaosadati (2002) observed no effect of silicone oil addition (20% v/ v) on biofiltration of a mixture of hydrophobic compounds with hexane as the principal component (80%) at low inlet concentrations (1 g m−3), but when the inlet concentration was increased at 3 g m−3, an improvement of 10% in the removal efficiency was obtained.
