Sentence examples for inlet value from inspiring English sources

The dispersion coefficient K is shown to be equal to Ko/Π, where K is its inlet value.

The value of sulphate in inlet value ranges from 51.24 to 107.06 mg/l with an average of 82.85 mg/l and after treatment its concentration varies from 69.47 to 150.61 mg/l with an average of 99.22 mg/l.

Four zones are formed in the bed with the ternary mixture resulting from the desorption of carbon dioxide by water, the concentrations of the former rising above the inlet value.

Analysis of data previously collected from this flame shows the local equivalence ratio to vary by as much as 25% from its inlet value, with similar variations found for the atomic C/O ratio (up to 25%) and atomic C/H ratio (up to 10%).

For the first coated section partial pressures correspond to the well-defined inlet values and do not depend on time.

It is shown that using these profiles as the inlet conditions on an empty domain results in outlet profiles which are almost identical to the inlet values.

Also, comparison of water concentration values for three SP, SC and SB cases showed 35.6%, 49.5% and 43.57% of inlet values respectively.

Finally, these outlet results are input as inlet values of the (m + 1 th segment, and the distributions of pressure and temperature in IT and annuli are obtained from toe point to heel point.

Approximate analytical methods are presented for the estimation of steady state electrolytic concentration and temperature profiles, and for the determination of stable behaviour under small perturbations in their inlet values.

However, when φs2⪢1, surface ignition occurs very close to the inlet (or for very short residence times corresponding to large values of P) to a maximum surface temperature of B/(Lef a (a=1/2 for flat velocity and a=2/3 for parabolic velocity profile) while the fluid-phase conditions are still close to the inlet values.

The criterion limits the maximum allowable temperature on an objective basis and permits the calculation of the corresponding critical inlet values for the operating variables, like partial pressure of the reactant, temperature of the reactor fluid, temperature of the cooling medium, coolant flow rate, reactor throughput...